From:	chuck maize	Electronic:	hcmaize -A- hotmail.com
Subject:	RE: more +	Date:	Fri Apr 10 01:19:45 2009
Response to:	12446

Thanks, Mutt! BTW, did you say that most any condenser will work on my 175? Such as a typical lawnmower condenser? ----- ORIGINAL MESSAGE FOLLOWS ----- Here is the high speed needle assembly which consists of a leather packing (seal) a brass packing nut and the needle itself. Make sure the needle is sharp and not grooved or pitted. Drop the seal down into the hole. Insert the needle thru the seal and start to thread the needle into the carb body a couple of turns. Next, install the packing nut and start it a couple of turns. Screw the needle all the way in, BY HAND, until it lightly seated. Thighten the packing nut down. Now unscrew the needle 1 FULL turn out. Next ,install the upper (low speed) needle and spring. Screw it in by hand until it is seated, then back it out 3/4 of a turn. These are the Factory settings