From:Joe McWilliams Electronic:jmcwilliams -A- sfasu.edu
Subject:RE: RE: Flywheel plates? necessary or not? Date:Thu Jul 29 21:25:30 2010
Response to:14087
Perry,

Thanks for a great response, very informative. It raises a couple of other questions.

1. A heavier flywheel means slower revving, but higher torque. Higher torque on a small displacement engine like this is desirable, I would think , but will the greater inertia do harm to this little single?

2. Where can I take this crank to check it's balance? Is that standard equipment in any engine shop, or do I need to find a shop with a machine devoted to motorcycle cranks?

Thanks,

Joe

----- ORIGINAL MESSAGE FOLLOWS -----
They serve to raise the compression in much the same way as a stuffer plate does that the racers use. The photo of the flywheel shown isn't just missing its plate, it looks like the void has been filled with lead(?). This would have the same effect has the plate (while playing havoc with the balancing if not accounted for). Attached is a photo showing an unmodified flywheel without it's plate ... Perry

----- ORIGINAL MESSAGE FOLLOWS -----
When I split the cases on my '52 125S, I noticed that there were no flywheel plates (23730-47) flywheel. I got to wondering if they actually serve a useful purpose, or are they just to hide the ugly face of the flywheels (see pic)? I would appreciate a discussion of this among the older hands. Thanks.

Joe