From: | Dave Hennessey | Electronic: | dave -A- toyhouse.org |
Subject: | RE: RE: Engine Screws | Date: | Wed Dec 15 23:26:50 2010 |
Response to: | 14902 |
Mike, You done good. The information needed to properly restore your bike is out there. You just gotta dig. While this website doesn't have everything imaginable, it does have a lot - just keep digging. And if you can't find the answer, there's always the kindly folks on the Hummer Exchange who will steer you in the right direction. Dave ----- ORIGINAL MESSAGE FOLLOWS ----- 1948 engines had slotted screws, here's a picture from the factory archives (Thanks again Jerry!) Mike ----- ORIGINAL MESSAGE FOLLOWS ----- Does any one know if the screws on a early 1948 Engine cases and etc, use slotted head screws or phillip head screws. I see some sell kits but the screws all seem to be phillip head, and a lot of the screws have are slotted. Thank you in advance |