From:CJ e-mail:Mathsci-A-hotmail.com
Subject:RE: fork tube service Date:Mon Dec 9 21:52:27 2013
Response to:19047
Billy, any idea of the cost for straightening and re-bushing might be? Do
you have a way to deal with wear on the fork sliders (if that is what they are
called)?

Thanks

CJ

----- ORIGINAL MESSAGE FOLLOWS -----
wondering if there is any intrest, I have straighted tubes with in .010 I did
one this moring that was .190 tir and got it within .006 any where on that
tube (checked on a bench center) also pulled old bushings and made new
ones with more bearing surface 3.0" on top and 1.5" on bottom. just
checking intrest right now. I think they came pretty sweet. currently I have
four sets of straight tubes, two sets have new bushings ( have to get more
bushing material)

thanks Billy