From: | Dan Divan | e-mail: | Artdogali-A-bellsouth.net |
Subject: | RE: RE: RE: RE: tool | Date: | Sat Dec 13 12:22:27 2014 |
Response to: | 20063 |
OK I got it. back to the drawingboard. thanks for the cpmments ----- ORIGINAL MESSAGE FOLLOWS ----- Nope, you'll take the temper out of the main shaft and hub if ya get any where near that hot. ----- ORIGINAL MESSAGE FOLLOWS ----- well I tried that and Mutt says put some hair dryer heat on it too. Tryd both. still tight as hell. put liquid wrench on it too. no good. I'm shy to pry it very hard afraid to bend the clutch basket. has anyone put torch heat on it? 1100 degrees or so ----- ORIGINAL MESSAGE FOLLOWS ----- two large screw drivers is all it takes ----- ORIGINAL MESSAGE FOLLOWS ----- I need a tool for the clutch drive hub harley part # 95960-48 just can't get the thing off without it |