From:Backyard Bob e-mail:somewhere-A-newjersey
Subject:RE: Problem starting 1960 Date:Sun Aug 23 10:54:45 2015
Response to:20719
There are poorly made point sets out there. Check to be
sure they're not grounded out. Being new they may also have
a 'glazing' on the contact tips. Run a piece of fine
sandpaper over them. Also run a continuity check on each &
every wire in the ignition circuit to make sure there are
no internal breaks in the wire stopping the flow of
electricity.

----- ORIGINAL MESSAGE FOLLOWS -----
Just restored 1960 super 10. Put new points,condenser,
Cole. Still no spark.
What else can we check?