From: | CJ | e-mail: | mathsci-A-hotmail.com |
Subject: | RE: RE: RE: RE: '62 Pacer Toolbox | Date: | Wed Mar 29 11:51:45 2017 |
Response to: | 21870 |
The expertise around here is amazing. Thanks for your help Mutt and Dave. If you happen to run across your toolbox, Dave, a picture would be great to have. ----- ORIGINAL MESSAGE FOLLOWS ----- I just happen to have a NOS one around here somewhere. I can dig it out and take a photo if desired. Mutt is correct - there's an extra hole on the back. If I remember correctly, there's a little "dent" in the back, so the extra hole is at an angle. Not 100% sure, though. The 1955-1959 Hummers, and 1960-62 bikes did not have the toolbox mounting bracket on the frame, so a little U-shaped bracket is required to slip over the frame. Not sure if these were included with the toolbox or sold separately. Dave ----- ORIGINAL MESSAGE FOLLOWS ----- Also the 61-62 BT models have a special tool box. It as 2 holes in the back for mounting, instead of one on all the other models, due to the 16" wheels. Very hard to find in any condition ----- ORIGINAL MESSAGE FOLLOWS ----- Tools boxes were an accessory on 55-62 B BT BTH BTF models ----- ORIGINAL MESSAGE FOLLOWS ----- Just curious if the '62 Pacer came with a toolbox like the 165's, if a toolbox was an option, or if the Pacer had something else (like a tool roll). I have looked at a lot of pictures and have not been able to tell from what I found. Thanks for any assistance |
Sent from IP Address: 68.116.107.131
Lookup 68.116.107.131
Reverse Telephone Lookup