From:backyard bob e-mail:-A-somewherenj
Subject:RE: Piston ring bevels - up or down? Date:Sat Apr 28 19:39:06 2018
Response to:22653
With every bike I've owned I've always put the bevels down
and had no problem. I'm not a racer or a high miler on any
one resurrected bike and have owned several. You needed a
quick answer. Best of Luck....and have fun!

----- ORIGINAL MESSAGE FOLLOWS -----
Hi esteemed Harley Hummer gurus. Rookie
question here. I am very close to completing assembly of
my 1955 ST165 engine. You see in the photo that the
replacement rings have a been on one inside corner. Does
that bevel go towards the top of the piston (as currently
shown in the photo), or towards the bottom of the piston?

Hope for a quick answer so I cam complete the assembly and
get the engine off of the dining room table before my wife
gets home...

Sent from IP Address: 184.102.99.241
Lookup 184.102.99.241

Reverse Telephone Lookup