Page 2 of 2

Re: Mag ignition

PostPosted: Wed Aug 21, 2019 9:30 pm
by Backyard Bob
If you hold a screw driver next to the rotor and it pulls it in like John Wayne chasing the bad guys then it's probably okay. If it's more like Pee Wee Herman then Mutt's your choice. He's probably the only one left out there that does this.

Re: Mag ignition

PostPosted: Wed Aug 21, 2019 11:46 pm
by schrizo
CHECK for voltage at the coil. sometimes its the smallest thing.

Re: Mag ignition

PostPosted: Wed Aug 21, 2019 11:46 pm
by schrizo
CHECK for voltage at the coil. sometimes its the smallest thing.

Re: Mag ignition

PostPosted: Thu Aug 22, 2019 9:34 am
by KJohn
One problem I had was that I accidentally grounded the points at the connection. Check to be sure your connector is only touching the points, not grounding against the inner case.
John

Re: Mag ignition

PostPosted: Thu Aug 22, 2019 8:31 pm
by bbtwoscoot
Thanks Mutt, would you mind emailing me at bb2scoot@msn.com

Re: Mag ignition

PostPosted: Thu Aug 22, 2019 8:41 pm
by bbtwoscoot
Thanks again Bob, will give it a try.

Re: Mag ignition

PostPosted: Thu Aug 22, 2019 10:03 pm
by Mutt
Will do